Tagged: spi

HAL Library 33- DMA extension for SPI on STM32Fxxx 21

HAL Library 33- DMA extension for SPI on STM32Fxxx

SPI DMA library allows you to send and receive data via SPI in non-blocking mode. It can be use for TX only, RX only or both (transmissing mode). This library is extension for my SPI library. It requires SPI library as basic to make this to work. Library Read more about HAL libraries Features SPI extension for non-blocking TX, RX or both modes Supports all SPI peripherals on STM32F4 and STM32F7 device Supports interrupt processing Allows you to start DMA transmissing and wait till done This is...

HAL library 08- SPI for STM32Fxxx 32

HAL library 08- SPI for STM32Fxxx

Next library in ported libs is SPI for HAL based drivers for STM32F4xx and STM32F7xx based devices. Library Read more about new HAL libraries Features Operate with up to 6 SPI peripherals Send single or multiple bytes at time Automatic SPI prescaler selection based on maximum clock selected for your external device Software based Chip Select pin Support for custom GPIO pins combination for SPI

All STM32 HAL libraries 106

All STM32 HAL libraries

In this section, I will write all libraries based on HAL drivers from ST. If you see this first time, make sure you read this post first about how structure of my libs looks like! License All my softwares are published under MIT license. This means that you are allow to modify, share and use my source and other stuff in personal or commercial use. If you modify source code, it has to stay under GNU GPL v3 license too. I...

Library 56- Extend SPI with DMA for STM32F4xx 18

Library 56- Extend SPI with DMA for STM32F4xx

As said in one post before, here is SPI DMA library for STM32F4 devices. Instead of onl TX functionality (as in USART DMA library) SPI DMA extension library enables DMA for TX and RX modes at the same time, to receive and transmit data over DMA. Library supports up to 6 SPIs (max number in STM32F4 devices). It can work in 3 main modes: Send data to slave device, receive data from slave device Send data to slave device, don’t...

Library 21- Read SD card with FatFs on STM32F4 582

Library 21- Read SD card with FatFs on STM32F4

Finally I got it working properly. Reading SDcard was very awesome for me for first time, so I decided to make a library for STM32F4xx devices and post it to my website. It’s basically just communication interface between STM32F4 and FatFS library by Chan. It supports SPI or SDIO communication. Library also supports USB communication, but for that purpose you need USB stack too. USB is available here. Below I’m showing how to setup everything with STM32F4 to get SD...

All STM32F4 libraries 128

All STM32F4 libraries

Because there is a lot of libraries I have done, I will make a table with all of my libraries at one place. When new library will be created, it will be posted here. These libraries work on both Discovery boards, if not, it will be specified. Actually, libraries should work on STM32F4xx series of microcontrollers if they have peripherals that are need for library. All STM32F4xx MCUs don’t have everything inside. 🙂 Libraries are tested on my 4 STM32F4...