Tagged: gyroscope

MPU-6050 6-axes gyroscope and accelerometer 1

HAL Library 30- MPU6050 for STM32Fxxx

After MPU6050 library for STM32F4xx series only based on STM32F4xx Standard peripheral drivers, I’ve redesign this library for HAL support over all STM32 series. It has some more features then my first library. It can now read data from MPU6050 (obvious), set interrupts for data ready and motion detection, read interrupts status, set custom data rate for data ready interrupt and set new gyro and accelerometer sensitivities on the fly. More about lib is describe below and on HAL API site. Library...

MPU-6050 6-axes gyroscope and accelerometer 113

Library 43- MPU-6050 6-axes gyro and accelerometer for STM32F4

MPU-6050 is a 3-axes accelerometer and 3-axes gyroscope MEMS sensor in one piece. It can also measure temperature. It is very cheap device but also very powerful. It can measure simultaneously three (X, Y and Z) channels for accelerometer and gyroscope at the same time with 16-bit resolution. This chip is also compatible with MPU9150, except that MPU9150 has 3axes magnetometer (or compass) included. MPU-6050 Features Accelerometer 4 selectable full scales (2G, 4G, 8G and 16G) Gyroscope 4 selectable full scales...

L3GD20 3-axis digital gyroscope example 10

Library 28- L3GD20 3-axis digital gyroscope

MEMS sensor L3GD20 is included on STM32F429-Discovery board, so I made a library to use it. This is 3-axis digital gyroscope, so it can measure rotation in X, Y and Z axis. L3GD20 sensor works with SPI communication, or I2C. On Discovery board is connected for SPI mode, SPI5 is used for communication. L3GD20 can be set to work in 3 different full scales: 250, 500 and 2000 dps. Sensor has also possibility to measure temperature, but this is not...

All STM32F4 libraries 128

All STM32F4 libraries

Because there is a lot of libraries I have done, I will make a table with all of my libraries at one place. When new library will be created, it will be posted here. These libraries work on both Discovery boards, if not, it will be specified. Actually, libraries should work on STM32F4xx series of microcontrollers if they have peripherals that are need for library. All STM32F4xx MCUs don’t have everything inside. 🙂 Libraries are tested on my 4 STM32F4...